![]() when scrolling a list, flirc may not be responsive and continue to scroll a little longer than you want). Make sure you have the at least firmware version 2.6. Key repeat rate may not be desirable (i.e. The Harmony has a built in profile for XBMC thats been fine tuned to work perfectly with flirc. If nothing is assigned to the button then the button won't be mappable using Flirc GUI as nothing is being sent when it is pressed.Īlso, by default each button is assigned something different, when changing or adding buttons ensure the same action isn't assigned to different key, this will prevent "Button already exists" error when configuring Flirc through the GUI. the subtitle button may not have anything assigned to it for the panasonic device). Using the harmony software or, ensure all buttons have something assigned to them (e.g. In Harmony software or the online utility choose from one of the two option below (best to choose a tv that isn't the same brand as the one you are using) To add further keys to the remote control see this article You should be good to go - you don't need to program buttons using the Flirc gui, we've done that for you. I'm trying to discover if i just got lucky since i originally bought this to use for xbmc and switched to the XBMC Controller and automatically got those presets, then found out about the Logitech Profile for XBMC and then setup my profile on and since the two matched for the most part i in-fact got lucky with the actual setup as.(If you're using the harmony software you'll have to choose the device "Media center PC")ĭepending on the Harmony remote model you may have to create an activity that uses the "XBMC Device" Now that I have added the Pi/Flirc setup, with the XBMC Activity set defined in the Harmony there seems to be a lot of command bleed over, at first I thought it was both directions but it seems it just that the Pi (Flirc) responds to WMC commands, but not the other way around. Go to harmony software or and add a new device.Plug in Flirc and open the Flirc software - the software should automatically upgrade the Flirc firmware (if required). ![]() Make sure you are running the latest version of FLIRC GUI software
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |